Search found 203 matches

by curtusz
Wed Dec 04, 2019 12:07 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Help regarding euro fn2 flashpro
Replies: 2
Views: 40

Re: Help regarding euro fn2 flashpro

A couple of knocks is nothing mate could be low quality fuel .. set up your ecu to flash when knock occurs ...low ron fuel or/and lugging the engine (eg 6th low rpm foot flat) can cause knock
by curtusz
Thu Nov 28, 2019 5:54 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Lambda very lean at WOT!
Replies: 6
Views: 393

Re: Lambda very lean at WOT!

No datalog but I was getting 16af on wot changed oring seals and reuploded kal (as ECU was trying to learn with bad seals)
by curtusz
Wed Nov 20, 2019 3:36 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Lambda very lean at WOT!
Replies: 6
Views: 393

Re: Lambda very lean at WOT!

Could be injector oring seals, happened to mine (not supercharged)
by curtusz
Tue Aug 20, 2019 10:23 am
Forum: K-Pro / KManager
Topic: Best wideband for kpro4
Replies: 16
Views: 3477

Re: Best wideband for kpro4

Yeah that sounds correct they will both need a signal from the lambda not sure which way round on voltage (not sure why it matters) , there will more than likely be an offset that will need to be calibrated (Just try and calibrate it to same as gauge) and you will need to use the smoothing to slow t...
by curtusz
Fri Aug 16, 2019 3:29 pm
Forum: K-Pro / KManager
Topic: Best wideband for kpro4
Replies: 16
Views: 3477

Re: Best wideband for kpro4

Check through this post i made a diy its old so i dont know how relevent it is now

viewtopic.php?f=12&t=18380&start=15
by curtusz
Wed May 15, 2019 9:44 am
Forum: FlashPro Manager
Topic: Cam ignition table help please
Replies: 7
Views: 679

Re: Cam ignition table help please

You can do it that way. You don't exactly need to tune it .. but what if your vtec solenoid stops working and car doesnt go in to high cam. And you lean out bad ? Its just a fail safe to tune as much as you can
by curtusz
Wed May 08, 2019 1:36 am
Forum: FlashPro Manager
Topic: Cam angle map info??
Replies: 23
Views: 3507

Re: Cam angle map info??

Edit all the tables to 0 degrees and tune then to 10 degrees then tune.. ect .. then once you've done it all set the cam angles to where you make peak torque
by curtusz
Tue Apr 16, 2019 4:07 am
Forum: Civic Type R 2007-2011 European FN2
Topic: General question K20 - popping/crackle noise for a "sport mode" possible?
Replies: 22
Views: 11917

Re: General question K20 - popping/crackle noise for a "sport mode" possible?

I don't have the software in front of me right now to tell you . But i rememeber it was just rpm based for when the injectors cut and restart I just set that way high so the injectors don't shut off and it will gargle and pop all the way down on deceleration. When I've finished work I will take a lo...
by curtusz
Thu Mar 21, 2019 11:49 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Help - FN2(2007) with CPL Racing CAI
Replies: 3
Views: 1335

Re: Help - FN2(2007) with CPL Racing CAI

I use target lambda tables on group n basemap. Haven't had time to tune but fuel is always where it needs to be . Have active tuning enabled also. Strims are not too bad aswell
by curtusz
Thu Jan 03, 2019 12:53 pm
Forum: FlashPro Manager
Topic: Calibration question
Replies: 1
Views: 243

Re: Calibration question

You can delete secondary o2 sensors with I believe is a tick box job on any map . Just tick the box and reupload .. also I think factory basemap and the n group map would be suitable.. tick the flash eml when knock detected .. and datalog and/or use the af ratio feature on the rev counter to check y...
by curtusz
Tue Dec 04, 2018 11:34 am
Forum: Civic Type R 2007-2011 European FN2
Topic: General question K20 - popping/crackle noise for a "sport mode" possible?
Replies: 22
Views: 11917

Re: General question K20 - popping/crackle noise for a "sport mode" possible?

Just alter overrun recover/restart .. it will just gargle and pop away on deceleration .. kinda annoying after a while for me personally .. I would recommend having as a second map on the flashpro just so you can change it back easier .. also can't really be good for cylinder walls and piston rings ...
by curtusz
Sun Nov 11, 2018 10:32 am
Forum: Civic Type R 2007-2011 European FN2
Topic: FN2 won't work with any MAF calibration (running extremely lean)
Replies: 6
Views: 1860

Re: FN2 won't work with any MAF calibration (running extremely lean)

Wow 19.. that is lean .. I've always used target lambda .. never had an issue .. I'm on 2011 euro fn2 .only time I hit 19 is on deceleration (fuel cut) .. all I could say is try a factory or n group map .. see if that resolves it .. dont really see the point of fine tuning fuel unless your boosted. ...
by curtusz
Wed Sep 12, 2018 3:29 pm
Forum: Civic Type R 2007-2011 European FN2
Topic: Fresh installed group n map
Replies: 15
Views: 3213

Re: Fresh installed group n map

I will check it later when I have some time .. I have an aem 320lph pump in my garage left over from an ep3 I used to own and an aem uego a/f gauge .. I will try the factory map and do some testing find out if it's a bad lambda or pump or software .. thanks for the info
by curtusz
Tue Sep 04, 2018 5:02 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Secondary wideband
Replies: 2
Views: 1703

Re: Secondary wideband

Don't need to there is an option to view it on rev counter .. although I've no idea how accurate oem lambdas are
by curtusz
Tue Sep 04, 2018 5:00 am
Forum: Civic Type R 2007-2011 European FN2
Topic: Fresh installed group n map
Replies: 15
Views: 3213

Re: Fresh installed group n map

I'm using n group map and I'm finding I get a lean condition at 2000rpm and below in 6th at wot ... although it's using target lambda values.. not really a problem as don't usually lug the engine .. but do find it odd