Search found 9 matches

by stoner51
Sun Mar 16, 2014 9:37 am
Forum: Coil Pack Retrofit
Topic: Coil Pack Retrofit
Replies: 88
Views: 58973

Re: Coil Pack Retrofit

So I finally got around to installing the CPR kit today. Despite my attempts for it not to work. Like everything else I have hondata it works fine. Thank you Spunkster and hondata for the Help. I only had one problem and that is because I changed the settings but failed to update the ECU once I did ...
by stoner51
Tue Feb 18, 2014 5:28 pm
Forum: Coil Pack Retrofit
Topic: Coil Pack Retrofit
Replies: 88
Views: 58973

Re: Coil Pack Retrofit

So I should be ok? You may want to edit the help page to reflect the change. Could somebody measure the length of their coil? And I can measure this one to compare? thanks for all the help. And I haven't even installed it yet. steve EDIT seal removed It measures 130mm to the inside of the coil where...
by stoner51
Tue Feb 18, 2014 5:07 pm
Forum: Coil Pack Retrofit
Topic: Coil Pack Retrofit
Replies: 88
Views: 58973

Re: Coil Pack Retrofit

http://www.oemacuraparts.com/oem-part/oem-acura/coil-plug-hole/30520pvja01?search_str=30520-PVF-A01 That is the part I ordered I cut one and does seem short. It doesn't have a tight fit at all. I edited the first post. steve This is from another honda site http://www.hondapartsnow.com/genuine/honda~...
by stoner51
Tue Feb 18, 2014 4:46 pm
Forum: Coil Pack Retrofit
Topic: Coil Pack Retrofit
Replies: 88
Views: 58973

Re: Coil Pack Retrofit

I ordered the CPR and the coils. I apparrently didn't look at the order to carefully and I ordered 30520-PVJ-A01 not the PVF Before I cut the tab off can you tell me if this coil is long enough? It says the one I ordered is a replacement for the pvf, however it seems short in length. Should these fi...
by stoner51
Mon Feb 03, 2014 11:52 am
Forum: Coil Pack Retrofit
Topic: Coil Pack Retrofit
Replies: 88
Views: 58973

Re: Coil Pack Retrofit

Thanks for the prompt response. I don't have much confidence in my ability to remove the plugs. I may try again at the JY before attempting on my car. But If I can't I can solder and the then just splice in later should I decide to change it out. More trouble but less trouble than me jacking up my m...
by stoner51
Sun Feb 02, 2014 7:42 pm
Forum: Coil Pack Retrofit
Topic: Coil Pack Retrofit
Replies: 88
Views: 58973

Re: Coil Pack Retrofit

I Have a few questions before I decide to go this route or not. I have had no luck pulling the ecu pins out without destroying the plug. Can I clip the affected wire say 5 inches from the plug and solder in the CPR side to the short wire. Will the H22 cover hold the coils in or do I need to fab up s...
by stoner51
Sun Sep 22, 2013 6:28 pm
Forum: s300 / SManager
Topic: Rich at idle when hot
Replies: 2
Views: 1095

Re: Rich at idle when hot

Thank you for answering. I have adjusted the tune some and have got this a lot better. My problem was I was only adjusting the 3rd column. My second column was too low and when the car had very little load it would lean out. I have adjusted more fuel in the 2nd column and have got this to about wher...
by stoner51
Fri Sep 20, 2013 2:52 pm
Forum: s300 / SManager
Topic: Rich at idle when hot
Replies: 2
Views: 1095

Rich at idle when hot

This may be a simple job for a tuner to solve. But It hasn't always been this way. I just noticed this over the past couple weeks. I have a 97 JDMh22 obd2 obd1 dizzy and injectors stock h22 obd2 map sensor car 1991 accord, pt24 tranny, lc-1 wideband resistors removed. I can't remember which ones but...
by stoner51
Tue Apr 16, 2013 4:55 am
Forum: s300 / SManager
Topic: TDC sensor error code ( N°8)
Replies: 5
Views: 2536

I think the cruise control is controlled by another computer.

But would It be possible to use the cruise button as an on/off for datalogging?

thanks

steve