Search found 10 matches

by alex
Mon May 22, 2006 11:56 pm
Forum: s300 / SManager
Topic: Can this option be added to the hondata?
Replies: 4
Views: 1880

hate to append to a preexisting thread...

but could an option be added to display MAP sensor voltage?
by alex
Mon May 22, 2006 11:53 pm
Forum: s300 / SManager
Topic: First Time Using Hondata/Can't Get IT TO Idle Smoothly
Replies: 8
Views: 2671

what map sensor are you using?
by alex
Mon Apr 24, 2006 6:42 pm
Forum: s300 / SManager
Topic: Starting problems
Replies: 5
Views: 1950

only when refueling and on some startups (can't recall).

But that purge valve is what's causing it. I unplugged it and never had the problem again.
by alex
Mon Apr 24, 2006 8:05 am
Forum: s300 / SManager
Topic: controlling boost with hondata?
Replies: 3
Views: 2012

I am helping a buddy test out his electronic boost controller design. It has a nice feature to wire in a switch for high and low boost settings. It's a simple loop to ground so it will be easy to control via the AUX output.

I'm sure most ebc's have this type of feature.
by alex
Mon Apr 24, 2006 7:56 am
Forum: s300 / SManager
Topic: Starting problems
Replies: 5
Views: 1950

try to just unplug the harness connector to the purge valve. I was having the same problem.
by alex
Mon Apr 24, 2006 7:47 am
Forum: s300 / SManager
Topic: gm 3barmapsenser
Replies: 20
Views: 11044

alex wrote:Does anyone know if the Smanager allows you to view the MAP reading in just the voltage?
by alex
Thu Apr 20, 2006 11:08 am
Forum: s300 / SManager
Topic: dataloging
Replies: 20
Views: 8464

would the ferrite core be placed closest to the ecu?

Seth, when the datalogging stops, do you have to unplug the USB cable and then plug it back in to get the PC to recognize the connection?
by alex
Fri Apr 07, 2006 12:36 am
Forum: s300 / SManager
Topic: gm 3barmapsenser
Replies: 20
Views: 11044

crucian: I tried your values given above and it did in fact remove my bouncing idle issue. However, the vacuum reading on my mechanical gauge is not matching up to the reading in SManager. For example, my mechanical gauge would show b/w 20-21"Hg while SManager shows 18"Hg. This seems off throughout....
by alex
Thu Mar 02, 2006 4:29 pm
Forum: s300 / SManager
Topic: gm 3barmapsenser
Replies: 20
Views: 11044

right....so i guess I should just buy a motec sensor
by alex
Fri Feb 24, 2006 10:19 am
Forum: s300 / SManager
Topic: gm 3barmapsenser
Replies: 20
Views: 11044

For what this might be worth, I purchased a "gm" 3bar map sensor from lightning motorsports which is actually an MSD 3bar sensor. MSD gave me the following info: 5v @ 43.5psi and (of course) 0v @ 0psi The slope would be 599.844 mbar/volt While this is close to the Motec 3bar, i'm not sure about the ...