Search found 6 matches

by BoostedK
Wed May 04, 2016 8:08 pm
Forum: TSX 2004-2014
Topic: Immobilizer Programming
Replies: 3
Views: 4171

Re: Immobilizer Programming

Thanks, just wanted to avoid any confusion.

On a side note, I noticed the 06-08 tsx has map sensor 37830PNC003. While my 04 has 37830PGKA01. Is there any difference or need to switch to the 06-08 version?
by BoostedK
Thu Apr 21, 2016 7:59 pm
Forum: TSX 2004-2014
Topic: Immobilizer Programming
Replies: 3
Views: 4171

Immobilizer Programming

Hi, when going through the process of immobilizer programming do I have to go to an Acura dealership? The Nearest Acura dealer is 40 miles away while a Honda dealer is <5 miles away.

I am using an 07 ECU into a 04 TSX.
by BoostedK
Sat Mar 12, 2016 6:19 pm
Forum: FlashPro Manager
Topic: Throttle body swaps
Replies: 40
Views: 63183

Re: Throttle body swaps

Where is the IC here? This is from the s2000, 06-08 TSX DBW driver.
image.jpeg
image.jpeg (2.72 MiB) Viewed 35383 times
If it is the big square chip here is the best I can do photography wise. It has some potting compound on it making it nearly illegible. I tried searching but didn't find any info.
by BoostedK
Sat Nov 17, 2012 10:51 pm
Forum: K-Pro / KManager
Topic: Oscillating air fuel ratio
Replies: 1
Views: 1595

Oscillating air fuel ratio

I noticed if I enable my secondary o2 sensor under the "closed loop" tab my air/fuel ratios and short trim will oscillate +/- 1-2%. The A/F ratio and s.trim are stable in open loop and if I disable the secondary o2. Any ideas as to why?
by BoostedK
Fri Feb 17, 2012 2:40 pm
Forum: K-Pro / KManager
Topic: Secondary O2 sensor and s. trim
Replies: 1
Views: 1241

Secondary O2 sensor and s. trim

I wanted to know if the secondary o2 sensor had anything to do with fuel trims. I have tuned my car to +/- 2% short term trims. Its stays there until the secondary o2 voltages goes up (around 0.8-0.9v) then the short term trim goes to +/- 10%. During cruise my o2 voltage is at 0.19v and will spike t...
by BoostedK
Sun Oct 30, 2011 10:09 am
Forum: K-Pro / KManager
Topic: KManager V3.0.3
Replies: 46
Views: 25788

Re: KManager V3.0.3

Is there a way to highlight the cells that were used during a drive cycle? It would be like map tracing but it would keep those cells would remain highlighted.