Hondata

I would like to request rev limit by gear. In addition, the addition of rev limit recovery similiar to flashpro would be nice as well.

I will do that. Thank you

Thank you. Ive been using a26 for a datalog switch for years. My steering rack has failed, and Im looking to change pins due to the failure. No other option on the manual datalog switch drop box will work for an S2000. PSP is needed for the electric rack SCS is needed for reading codes for SRS and E...

The electronic power steering module on 00-05 S2000s sends a signal to the engine ecu via A26.

Is this function supported with kpro?

Thank you, the sensors read out correctly now.

You should add that to the kpro help screen for analog pressure inputs

- what vehicle you have 2001 S2000 - serial number of your K-Pro - version of software being used 4 - KManager version 4.3.2 - the calibration (as an attachment) - when and where you got the K-Pro Bought Kpro 4 new 2 months ago Gentlemen, I am having issues with the analog inputs for my oil and fuel...

Ok. Thank you for your help

Ok. Can you please provide me with an acceptable way to ground the 5 v sensors?

Thank you.

I was able to find information from AEM for teh Series 2 stand alone directions. They list C28 as available for 5v power, and A31 as available for 5v ground.

Are these 2 pins acceptable for power and ground? I do not want to use power or ground connections that are already in use.

Thank you for the prompt reply, even on a Sunday night! Much appreciated! I try to practice correct wiring, and I know you guys are picky with how a car is wired with Hondata, so I apologize if I am asking simple questions. Can run all 5 sensors without issue on the single 5v source from the ecu, or...

Hello, I am adding an Ethanol content sensor, AEM Inline WB02, GaugeART CAN Gauge, and multiple AEM temperature and AEM pressure sensors to my S2000 Kpro 4. What are the recommended sources for 5v power and 5v ground on the S2000 ECU connections? The Kpro help page for analog inputs does not list a ...

Hmm, I called an Javier told me it does (before I saw your reply).

I will hold on to my speedo healer until spring when I can test this. But, if you say no then I expect it to do what you say.

For the VSS options, S2000 uses a countershaft VSS. When adjusting the speedometer conversion option. If this is changed to either a + or - value, will the changes be seen in the gauge cluster or only internal kpro parameters for tuning? I am in the middle of cleaning up/rewiring my ecu area after h...

Another vote for aftermarket sensor parameters wired into kpro4 via analog or digital input and being able to be seen on a Bluetooth/canbus device.

s2000 - would like the ability to adjust the coolant temperate gauge scaling similar to this: http://www.modifry.com/image/cache/data/prod/elec/ap2-compare-600x600.jpg This would be extremely helpful. Please be sure to make it editable for both AP1 and AP2 Clusters, but especially the AP1 with it o...