| Introduction |
 | Introduction to the K-Series Programmable ECU |
| Features |
| What's new in this version |
| Software License Agreement |
| Installation |
| Installation overview |
| Installing KManager software |
| Installing USB drivers (XP) |
| Installing USB Drivers (Vista) |
| Installing the ECU in the Vehicle |
| Manual USB driver installation |
| Calibrations |
| Introduction to calibrations |
| Uploading calibrations to the ECU |
| Upgrading calibration files |
| S2000 KPro |
| Datalogging |
| Introduction to datalogging |
| On board datalogging |
| Sensor Setup |
| Export Datalog |
| Tuning your vehicle |
| Tuning cam angle tables |
| Tuning fuel tables |
| Tuning ignition tables |
| Tuning the VTEC point |
| Windows |
| Settings |
| Main Window |
| Undo History |
| New Calibration |
| Create Forced Induction Tables |
| Adjust Selected Values |
| Table Window |
| Lambda Overlay |
| Changing Table Index Values |
| Changed Value Highlight |
| Graph Window |
| Datalog Comments |
| Graph Templates |
| Parameters Window |
| Fuel Trim Parameters |
| Fuel Compensation |
| Rev Limit Parameters |
| MAP Parameters |
| MAP Scalar and Offset |
| Adding a MAP Sensor |
| VTEC Parameters |
| Nitrous Parameters |
| Closed Loop Parameters |
| Closed Loop Target Lambda |
| Idle Parameters |
| Ignition Compensation |
| Knock Sensor Parameters |
| Knock Control |
| Protection Parameters |
| Lean Protection Parameters |
| Gear Compensation Parameters |
| Datalogging Parameters |
| Sequential Shift Cut Parameters |
| Boost Control |
| Boost Controller Installation |
| Boost Control Parameters |
| Boost Control Example Graphs |
| Misc Parameters |
| Multiplexer Parameters |
| Advanced Parameters |
| Notes Parameters |
| Analog Inputs |
| Analog Wideband |
| Analog Pressure |
| Analog Wiring |
| Digital Inputs |
| Serial Formats |
| Wideband Input |
| Sensor Window |
| Display Window |
| Error Codes Window |
| KPro Window |
| Security |
| Commands |
|
| Email Files |
| Compare Calibrations |
| Download |
| Erase ECU |
| Protect ECU |
| Clear DTCs |
| Set Readiness |
| Updating KPro firmware |
| Check for Updates |
| Update USB Drivers |
| Send support information |
| Reference |
| Sensors |
| RPM |
| VSS |
| MAP |
| CLV |
| TPS |
| CAM |
| CAMCMD |
| INJ |
| DUTY |
| IGN |
| IAT |
| ECT |
| AF |
| AFCMD |
| S TRIM |
| L TRIM |
| Fuel Status |
| K Retard |
| K Level |
| K Thres |
| K Count |
| PA |
| BAT |
| ELD |
| PTANK |
| RVSLCK |
| BKSW |
| ACSW |
| ACCL |
| SCS |
| EPS |
| FLR |
| VTP |
| VTS |
| FANC |
| MIL |
| ECU Connectors |
| Retrieving DTCs |
| Serial Output |
| Vista Virtualization |
| Troubleshooting |
| USB troubleshooting |
| Programmer troubleshooting |
| TPS Ignition Problem |
| Error Reporting |
© 2011 Hondata, Inc.