s300j help...

EM1PWR · Post by **EM1PWR** » Thu Jul 13, 2006 1:15 am

I installed my s300j today but when i plug in the ecu I get a constant check engine light. Constant Red light from the s300. I can upload calibrations, but I can't datalog, and the car runs very lean. For Ic3, my hondata came shipped with a chip named AC373 instead of HC373... Could this be the problem? If not help please. The ecu i'm using is a JDM P08.

Post by **Hondata** » Thu Jul 13, 2006 9:40 am

It sounds like it is the socketing. Check all the soldered connections for bad joints / lifted tracks. The AC373 will work.

Post by **Spunkster** » Fri Jul 14, 2006 10:33 am

Make sure that J4 has been removed per the instructions on the website for socketing a JDM ecu for S300j.

EM1PWR · Post by **EM1PWR** » Sat Jul 15, 2006 1:54 am

Thanks guys. I took Hondatas advice and touched up all the solder connections and sure enough everything works now...