16 cel all sensors
16 cel all sensors
I just did a b18a1 swap on my crx I loaded up the p74 calibration on my s300 and it will idle then whenever you use any throttle it won’t go and dies and I have 16 errors in smanager all sensors
Re: 16 cel all sensors
What is the serial number that is on the s300 board inside the ECU?
From Help, About, what is the version of software you are using?
Is J12 cut on the ECU?
Who socketed this ECU?
From Help, About, what is the version of software you are using?
Is J12 cut on the ECU?
Who socketed this ECU?
Re: 16 cel all sensors
21424 Is the serial
I don’t believe j4 is cut
I’m not sure who socketed it as I’m not the original owner
And the version is 2.7.8.0
I don’t believe j4 is cut
I’m not sure who socketed it as I’m not the original owner
And the version is 2.7.8.0
- Attachments
-
- 3A9D74C5-CCB3-4122-A375-7DBAE0495618.jpeg (2.46 MiB) Viewed 530 times
Re: 16 cel all sensors
It worked just fine with my b20 b3 that was in it
It also is flashing a red light I don’t have another vehicle sadly to test it with
It also is flashing a red light I don’t have another vehicle sadly to test it with
Re: 16 cel all sensors
I did not ask about J4.
Is J12 cut?
Is J12 cut?
Re: 16 cel all sensors
Sorry I just wasn’t thinking clearly lol j12 isn’t cut
Re: 16 cel all sensors
It must be cut.
Re: 16 cel all sensors
How do I go about cutting it just snipping one of the ends off? And I’m just curious how’d it work with my b20?
Re: 16 cel all sensors
Yes just snip one end. Sometimes it works without it cut, but the instructions for socketing do include cutting or removing J12 as it is a must.