Hi all,
Purchased an aftermarket wideband sensor and hooked up the signal wire to an analog input for the kpro. However the kpro doesn't seem to recognise it.
I've attached a few screenshots but when attempting to select analog 0 of where I wired in the wideband signal it doesn't show the option to select it in the External wideband option under closed loop tab under parameters.
Any guidance would be appreciated.
Cheers
Aftermarket external wideband kpro setup
Aftermarket external wideband kpro setup
- Attachments
-
- Screenshot_20220722-120359.png (598.75 KiB) Viewed 270 times
-
- Screenshot_20220722-120410.png (620.15 KiB) Viewed 270 times
Re: Aftermarket external wideband kpro setup
Please close this thread, it's been resolved. Thanks.