Hello. On a US R18 turbo, we are using 1050 ID injectors. Everything works perfect with engine breaking the 400whp mark (forged R20) but we have a problem with hot starting. No matter what crank fueling settings I have tried, engine starts very hard when hot. COld starts are excellent with typical scaling (from 180cc to 1050cc injectors, no other changes). I really can't figure out why this is happening and I have come down to perhaps the reason being an initial prime pulse when ECU first sees RPM to wet the walls which is not scaled by hondata software. Any ideas? I do not think that prime pulse (if any) is shown in logs.
As another note, car was initially tuned to 270whp with 520cc injectors and everything worked perfectly. Hot starting problem arised when injectors were switched to 1050IDx.
Prime Pulse
FlashPro Manager software
Jump to
- General
- ↳ Hondata News
- ↳ Applications
- ↳ Non-Hondata
- s100/s200/s300
- ↳ s300 / SManager
- ↳ S300 Calibrations
- ↳ SManager Display Templates
- ↳ s100/s200
- ↳ Romeditor 4 Software
- ↳ HondaLogger Software
- ↳ Coil Pack Retrofit
- K-Series
- ↳ K-Pro / KManager
- ↳ K-Pro Calibrations
- ↳ KManager Display Templates
- ↳ K-Series Reflash
- FlashPro
- ↳ FlashPro Manager
- ↳ FlashPro Calibrations
- ↳ Accord 2008+ FlashPro
- ↳ Civic Si 2006-2011 Americas
- ↳ Civic Si 2012-2015 US/Canadian / 2013+ ILX
- ↳ Civic Type R 2006-2010 Japanese FD2
- ↳ Civic Type R 2007-2011 European FN2
- ↳ Civic Type R 2015+
- ↳ Civic 2016+ 1.5 Turbo Americas/Asia
- ↳ CRV 2017+
- ↳ CR-Z 2010-2012 US/Europe/Asia
- ↳ Fit 2007-2008
- ↳ RDX 2007-2012
- ↳ S2000 2006-2009 Americas/Europe/Asia
- ↳ TL 2007-2008
- ↳ TSX 2004-2014
- Traction Control
- ↳ General / Traction Control Manager Software
- ↳ Traction Control with S300
- ↳ Traction Control with KPro
- ↳ Traction Control with FlashPro
- Bluetooth Mobile Apps
- ↳ Hondata Mobile