hondata - trying to read error codes

HondaLogger datalogging software questions and answers.
Post Reply
ferris11
Posts: 4
Joined: Wed Dec 23, 2015 12:46 pm

hondata - trying to read error codes

Post by ferris11 »

I have a 2007 civic SI with a hondata flashpro. I did not do the tune on the car, so i'm pretty new at this. My car recently started misfiring and now I can't get it to start. i connected my laptop with the flash pro and to the odbII port. in the flashpro manager in the bottom left, I see that the driver and flashpro have green check marks but the odbII port and ECU have red X's. I would think I need those to be "green" to get any kind of data.
I have the ignition on. Any thoughts on how to get these "green" or if I don't need them in this state, how I can pull some error codes?

thank you
ferris11
Posts: 4
Joined: Wed Dec 23, 2015 12:46 pm

Re: hondata - trying to read error codes

Post by ferris11 »

Not sure how I got past this, but now, all lights are green including OBDII AND ECU.

Now that I ironed that out, can someone tell me how to read the error codes from the ECU?

Thanks
ferris11
Posts: 4
Joined: Wed Dec 23, 2015 12:46 pm

Re: hondata - trying to read error codes

Post by ferris11 »

so still trudging through this.

Any other way to check for errors in the ECU?

Thanks
User avatar
Spunkster
Site Admin
Posts: 22737
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: hondata - trying to read error codes

Post by Spunkster »

While datalogging just click the error codes button at the top and you can see any error codes in that window.
ferris11
Posts: 4
Joined: Wed Dec 23, 2015 12:46 pm

Re: hondata - trying to read error codes

Post by ferris11 »

Thanks Spunkster. appreciate it.
Post Reply