basemap d16y7 idle issues

s300 and SManager software questions & answers
Post Reply
MrAhhsum
Posts: 5
Joined: Mon May 07, 2018 7:14 pm

basemap d16y7 idle issues

Post by MrAhhsum »

I have attached config and datalog

I have aem wideband 4110 (i believe) connected to d10 on my jumper harness.


I have sporadic idle, and it doesn't seem to calm down. I am looking for any input I can get.


the idle is fluctuating on my hondata ecu, but if i plug in factory obd2a ecu , it idles fine. Any thoughts?
Attachments
test.skl
(45.49 KiB) Downloaded 108 times
test.s3d
(1.52 MiB) Downloaded 115 times
User avatar
Spunkster
Site Admin
Posts: 22741
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: basemap d16y7 idle issues

Post by Spunkster »

With the Idle controller unplugged, what does it idle at?
MrAhhsum
Posts: 5
Joined: Mon May 07, 2018 7:14 pm

Re: basemap d16y7 idle issues

Post by MrAhhsum »

the idle air control valve ? I will check. Thank you for your reply
User avatar
Spunkster
Site Admin
Posts: 22741
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: basemap d16y7 idle issues

Post by Spunkster »

correct
tolyan
Posts: 26
Joined: Wed Oct 04, 2017 10:06 am

Re: basemap d16y7 idle issues

Post by tolyan »

figured out?
MrAhhsum
Posts: 5
Joined: Mon May 07, 2018 7:14 pm

Re: basemap d16y7 idle issues

Post by MrAhhsum »

tolyan wrote: Sat Sep 29, 2018 9:40 amfigured out?

not yet, i have not had time to go out and play with the iacv yet as suggested. Im hoping to update this weekend.
MrAhhsum
Posts: 5
Joined: Mon May 07, 2018 7:14 pm

Re: basemap d16y7 idle issues

Post by MrAhhsum »

Okay, been so busy I haven't been able to get to the car.

I unplug the y7 iac and the idle gets steady (car was warmed up already) so I think it's junk or needs cleaned again. Thanks guys.

Still open to other input
MrAhhsum
Posts: 5
Joined: Mon May 07, 2018 7:14 pm

Re: basemap d16y7 idle issues

Post by MrAhhsum »

Come to think of it...
If the iacv works fine on stock ecu, and not my s300... Maybe it's a simple tuning issue.

Simple. Haha.

I've decided to wait to get running smooth until 8 get the build done. It's a toy anyways.

Thanks for the support people!
Post Reply