Recently I have had issues while trying to upload my various calibrations to flashpro. I receive the following error message in Flashpro Manager, when I click "upload":
Followed by:
This error occurs with every calibration I attempt to upload, even the stock calibrations. I've been using flashpro for about 2 years, and this issue has only just started. The interesting thing is, although I receive these error messages the calibration appears to still upload to flashpro. However, when flashing my car with flashpro, there have been instances where the calibration will not properly "flash" to my ECU. The "Program" light will just cut off and I won't get that signature reset sound when the flash finishes. When this happens I usually try again, and it works.
Currently I'm using V1.6.1 of Flashpro Manager
My firmware is up to date as far as I can tell.
Windows 7 64x
I haven't seen any other instance of this type of error. Can someone please advise?
Calibration Upload Error
Re: Calibration Upload Error
With everything plugged in and the key on, go to Help, and click on send information to Hondata support.
Re: Calibration Upload Error
It does not look like you have uploaded your calibrations to the FlashPro since updating to the new version of software. Please do this.
Have you also tried uploading from the laptop wit everything plugged into the car instead of uploading to the FlashPRo then uploading separately form the FlashPro to the ECU?
Have you also tried uploading from the laptop wit everything plugged into the car instead of uploading to the FlashPRo then uploading separately form the FlashPro to the ECU?
Re: Calibration Upload Error
I have tried uploading the calibrations to the flashpro since updating software, but due to the error messages I'm receiving, I don't think flashpro has recognized the uploads.
When I sent the information to Hondata, I did try uploading the calibrations directly from the laptop rather than from Flashpro. Surprisingly I got the same exact error messages, and the upload immediately cancelled.
When I sent the information to Hondata, I did try uploading the calibrations directly from the laptop rather than from Flashpro. Surprisingly I got the same exact error messages, and the upload immediately cancelled.
Re: Calibration Upload Error
We are looking into this further
Re: Calibration Upload Error
Do you have any updates on this issue?
Re: Calibration Upload Error
The new version of software is now avaialble for download from the downloads section of the website.