iOS Applications

[Hondata]

With iOS devices you can either use the Hondata Mobile app, or use any app which uses the elm327 protocol.

To run the Hondata Mobile app you need the iPhone 4S and later, iPod touch 3rd generation and later, iPad 3rd generation and later. iOS 6 or later must be used.

• App store

Many apps uses the elm327 protocol. The apps which we have tested are:

• DashCommand

[Gernby]

I was able to connect to my FlashPro from the Hondata Mobile app without any issues at all with my iPhone 5S, but could not figure out how to connect with DashCommand. Could you provide some tips?

[Hondata]

DashCommand only works via WiFi. Your phone needs to be jailbroken and a BT to WiFi bridge installed. I used roqyBT4 & roqyBT7. The passcode also needs to be 1234

[antkouv]

Is there an update on this? Can we connect an iphone to the Flashpro using Dash command?

[antkouv]

Hello. Do you know if we can connect the flashpro to the Racechrono app?

[vladvitt]

Hello. Do you know if we can connect the flashpro to the Racechrono app?

Hello, yes flashpro is able to connect and working with Racechrono.
I did it in in order to get logs from engimne ECU during track sesion.

There is onboard usinng flashpro + hondata https://youtu.be/TslQ3_2KK3M

Is only one thing have been occured, after some racechrono update the throttle opening maximium shows 76% only

[ceruttibuilt]

I’ve had a problem with my new KPro v4 not working with the hondata app on my iPhone. I have 2 different vehicles both with KPro v4. It works ok with one of the kpros and not with the other one. Only physical difference I see between the board is the newer board has a way bigger chip that looks like it would be the Bluetooth adapter (has a built in antenna).My newer KPro serial number is 67652 which will not work with the app. My older KPro is serial number 60290. They both have the latest firmware available.
The issue with the 67652 KPro is the app will briefly connect but only display zeros on all sensors displayed, then keep disconnecting and reconnecting for about 2-3 seconds at a time. Any insight?

[Spunkster]

With everything plugged in and the ignition in the on position, go to the Help menu and click on “send feedback”. Include a detailed description of the issue.

[ceruttibuilt]

Will do thank you