Anybody do a vtec killer build
-
- Posts: 13
- Joined: Fri Nov 20, 2020 8:25 pm
Anybody do a vtec killer build
So i did the vtec killer build and my car cant idle. I have a good base map and still no chance of idling. Does anybody have a similar setup with flashpro? If not i hope someone has a dual krpo harness for sale that they made years ago.
Re: Anybody do a vtec killer build
I'm also looking for some help on this for my setup. I'm getting way too much fuel and just flooding out my idle.
-
- Posts: 13
- Joined: Fri Nov 20, 2020 8:25 pm
Re: Anybody do a vtec killer build
Don't do it unless you go standalone. Im still trying to figure out a way to adjust my throttle plate so its slighty open on start up so my car can idle. Right now i created a vacuum leak and now my car idles fine. Im running stage 3 dc cams and it takes a lot of vacuum because of the high lift cams. So the motor will not be able to idle because it has low vacuum pressure. You're better off building the k24a2 head so u run into less problems
Re: Anybody do a vtec killer build
We're making two comparable motors with two slight changes. Instead of a single rocker, use a two-lobe vtec killer. They are also high compression, ported heads that flow about 370 cfm when using k10 8620.
coreball
coreball