Setting idle speed and max rpm
Setting idle speed and max rpm
Can anyone please advise.
-I run s300v3 on my H22 ek, the minimum idle speed and max rpm parameters seem to have no effect when when adjusted in SManager.
Launch limiter RPM works fine when enabled.
-I run s300v3 on my H22 ek, the minimum idle speed and max rpm parameters seem to have no effect when when adjusted in SManager.
Launch limiter RPM works fine when enabled.
-
- Posts: 155
- Joined: Tue Oct 10, 2006 10:13 pm
Re: Setting idle speed and max rpm
do you have an iacv hooked up and working correctly?
Re: Setting idle speed and max rpm
IACV removed due to space issues with SK2 IM and fire wall
Re: Setting idle speed and max rpm
Re: Setting idle speed and max rpm
Yes you need the IACV for it to idle properly.
Re: Setting idle speed and max rpm
Does the absence of IACV stop me from setting the max rpm limit?
As this is the problem i am having aswell as setting the minimum idle speed, note both edit settings are found in SManager.
Also the car idles well, when warm, idles slightly higher than I'd like hence why I'm keen to be able to set idle value
Re: Setting idle speed and max rpm
Without the calibration and a Datalog showing the issue it is hard to say what might be causing an rev limit.
Re: Setting idle speed and max rpm
Ok sure. Is anyone available to review my calibration + data log if I uploaded it somehow
Secondly
I have a voltage offset between between AFR Aem guage and s300. The gnd is good and running to thermostat housing. My offset is around -1.5V. Any suggestions?
Re: Setting idle speed and max rpm
Post your calibration and a Datalog so that we can see what might be going on.
-
- Posts: 155
- Joined: Tue Oct 10, 2006 10:13 pm
Re: Setting idle speed and max rpm
You can buy IACV relocation kits, just FYI
Re: Setting idle speed and max rpm
Hello
Please see my data logs whilst the car was parked.
One is rpm increase and the other i believe is idle.
I have also added the latest calibration iam using.
Im very new to this so help much appreciated
Thanks in advance
Please see my data logs whilst the car was parked.
One is rpm increase and the other i believe is idle.
I have also added the latest calibration iam using.
Im very new to this so help much appreciated
Thanks in advance
- Attachments
-
- 13.4.19.skl
- Current Calibration
- (45.08 KiB) Downloaded 154 times
-
- 13.4.19.s3d
- idle
- (1.3 MiB) Downloaded 148 times
-
- 13.4.19, rpm increase.s3d
- stationary rpm increase
- (885.86 KiB) Downloaded 136 times
Re: Setting idle speed and max rpm
If it is rev limiting at your VTEC activation point, then it sounds like you may have an issue with the ground at the thermostat housing.
Re: Setting idle speed and max rpm
Its not rev limiting, ive tried setting the rpm to something like 6000rpm to prove it works but it climbs way past this until i let off
Re: Setting idle speed and max rpm
Please describe the issue more clearly, as I do not understand.
Re: Setting idle speed and max rpm
Genius removes something called IDLE AIR CONTROL, and has no idea why they can't control idle.
Forums turn me into a basic white girl, cuz I can't even....
(For future readers:
I assume they're confusing max rpm in idle tab with the actual Rev limit. AKA the fuel cut around 1800rpm in case your IAC sticks open)
For the OP:
I say this out of pure love for your H22.. Close the SManager and seek the help of a professional. Or at least a high school level backyard mechanic.