Hondata Mode not working in 3.2.9

Civic 2016+ 1.5 Turbo
User avatar
Spunkster
Site Admin
Posts: 17775
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Hondata Mode not working in 3.2.9

Post by Spunkster » Tue Apr 09, 2019 3:21 pm

We have tested this repeatedly and have not been able to find any issues with how the Hondata mode works.

nappco
Posts: 24
Joined: Wed Mar 27, 2019 4:30 am

Re: Hondata Mode not working in 3.2.9

Post by nappco » Tue Apr 09, 2019 4:17 pm

Spunkster,
Agreed, ...and after I converted all of the Bar values over to PSIg I can see that my datalogs are exactly where they should to be. So, was there a problem with the old +6 PSI tune? Was it overboosting? Was the cylinder fill knock air limit different? I noticed the +7 PIS boost is gone from the calibrations. Why? Finally, there is a warning as to clutch slippage with +9 psi, at what gear and or RPM? I assume the faster you are going, the less likely the clutch is to slip. This can now be corrected with boost by gear. Thoughts?

User avatar
Spunkster
Site Admin
Posts: 17775
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Hondata Mode not working in 3.2.9

Post by Spunkster » Wed Apr 10, 2019 11:36 am

There have not been any problems with the calibrations. There never was a +7 PSI calibration. The warning applies to using the +9PSi calibration. It really depends on how you drive the car and how hard on the clutch you are and have been.

Post Reply