Where do retrofitted ABS sensor wires need to go?

Post Reply
Listerofsmeg
Posts: 27
Joined: Fri Nov 18, 2011 8:14 am

Where do retrofitted ABS sensor wires need to go?

Post by Listerofsmeg »

Hi,

I dont think this has been asked, i have checked a lot of threads on here for similar questions.

If i were to retrofit ABS sensors on to my car, where do i send the wires? as i wont have the control unit and my loom is 100% custom, so there is no loom to plug them in to etc. Is it simply a case of power from the TC module and a ground to chassis?

I have EK9 front and rear hubs, so OEM sensors will bolt straight on, but after that.....what would i need to know? (Assuming i were to purchase the Hondata TC module).

Thanks,
Neil
UK Time Attack EK Civic
B18 Turbo
User avatar
Spunkster
Site Admin
Posts: 22737
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Where do retrofitted ABS sensor wires need to go?

Post by Spunkster »

Have you read the info in the traction control help file:

http://www.hondata.com/help/tractioncon ... wiring.htm
Listerofsmeg
Posts: 27
Joined: Fri Nov 18, 2011 8:14 am

Re: Where do retrofitted ABS sensor wires need to go?

Post by Listerofsmeg »

great! Sorry i should have spotted that on the site.

So basically a 12v feed to the sensor and grounded via the module per sensor. Perfect.
UK Time Attack EK Civic
B18 Turbo
Post Reply