VitViper wrote:Yes... I had one come into the shop last month, had a discussion with Doug about it... the ECU is "R9B-A03", which is listed as supported in the 1.6.3 update:
[ILX] Added support for the R9B-A03 ECU
However that's not the case -- FlashPro refuses to recognize the ecu and will not lock/flash the car. We were told this would get fixed in the "next beta". :/
We even had him send support info like 4 weeks ago, per Doug's request.
Yes, we added the binary R9B-A03 in 1.6.3 but the problem you had was related to the ECU part number. It should work now.
I suspect as much -- we'll try 1.8 on it and see how it goes.
Hondata wrote:
So you want misfire disable on the 06 Civic? We'll add it in.
Absolutely, it's been a problem with the 06-11 Civic calibrations for months -- I cannot use any very large injector without triggering a million codes.
If i try this: 1. Plug the FlashPro into the diagnostic connector and switch on the vehicle ignition.
· Primary calibration - press the Program button for at least one second.
· Secondary calibration - holding the Datalog button down, press the Program button for at least one second, releasing the Program button before the Datalog button."
Than the FlashPro does nothing!
I have also upload the Cals again from the Notebook to the Flashpro and than from the Flashpro to the ECU, but the same as before! :(
just wonder if the link to 1.8.0 was removed? for some reason I get a error and it states "not found" also I have tried updating thru flashpro manager and It keeps stating programing is not a 32 bit program and closes down. just wondering if anyone else is having this issue?
V1.8.1 (4 Apr 2014)
• FlashPro firmware updated to version 63
• Bluetooth enabled
• [2012+ Civic] Added support for RX0-K020 through RX0-K060
• [07-08 TSX] Added ability to program AT ECU with MT program
• [TL] Added ability to program AT ECU with MT program, only base model ECU (RDA-A85)
• [2006 R18 MT Civic] Added support for the RNA-A150 calibration.
• [CR-Z] Fixed misfire code disable.
• [CRZ-Z] Added support for RTW-H510 and RTW-U510
May I know does it mean FlashPro is now supported ECU part number RTW-U51? Any different between RTW-U510 and RTW-U51?