idel speed goes to ~600rpm | bug or not tuned correctly?
Posted: Tue Jun 23, 2015 10:53 pm
Hi,
I found a new / old problem. If the car is moving and pressing the clutch (Gear is still entered) the rev meter drops to idle speed not correctly it goes down to ~600 rpm.
If ~600 rpm is reached the ECU increase the idle speed to >1.000 rpm. The idle speed of 800 rpm is configured.
But if I pressing the clutch and shift to idel (N) the rpm will not drop to ~600 rpm. It works correctly
I searched in the hondata flash pro documentation to understand whats going on (to adjust the idle speed correctly) but in this case I could not found any solution.
So I filmed today the issue:
https://youtu.be/xdaH8q_sVA4
I think the car could not find the open-loop.
> Maybe the "MAP WOT determination pressure" is not configured correctly (to low)?
Or
> "WOT lambda adjustment low" is to low? I will not increase the values of this part!
I will post in the evening the MAF-Cal for my FN2 S/C
I hope anybody could help me. In advance thank you very much for your support!
I found a new / old problem. If the car is moving and pressing the clutch (Gear is still entered) the rev meter drops to idle speed not correctly it goes down to ~600 rpm.
If ~600 rpm is reached the ECU increase the idle speed to >1.000 rpm. The idle speed of 800 rpm is configured.
But if I pressing the clutch and shift to idel (N) the rpm will not drop to ~600 rpm. It works correctly
I searched in the hondata flash pro documentation to understand whats going on (to adjust the idle speed correctly) but in this case I could not found any solution.
So I filmed today the issue:
https://youtu.be/xdaH8q_sVA4
I think the car could not find the open-loop.
> Maybe the "MAP WOT determination pressure" is not configured correctly (to low)?
Or
> "WOT lambda adjustment low" is to low? I will not increase the values of this part!
I will post in the evening the MAF-Cal for my FN2 S/C
I hope anybody could help me. In advance thank you very much for your support!