AFT Tune causes Limp Mode?
AFT Tune causes Limp Mode?
Hello, all. I have a 2006 Civic Si and currently live tuning "Active fuel tuning high" and "Active fuel tuning low" and I get a check engine light and the vehicle goes into what I think is Limp Mode. I cannot go above 3,000RPM. Could somebody take a look at my calibration and datalog to see why this is happening? Thanks
- Attachments
-
- Datalog-171010-003.fpdl
- Datalog
- (150.36 KiB) Downloaded 104 times
-
- Hondata.fpcal
- Calibration
- (22.43 KiB) Downloaded 112 times
Re: AFT Tune causes Limp Mode?
says you have a p0101 cel MAF sensor
Re: AFT Tune causes Limp Mode?
P0101 is when the MAP does not match the AFM. You can either tune both the speed density tables and the AFM calibration, or disable the P0101 error if only using speed density.
Hondata
Re: AFT Tune causes Limp Mode?
Thank you! How would I go about doing tuning the Speed Density and AFM? Can I do it though Live Tuning? Thank you again!
Re: AFT Tune causes Limp Mode?
If the vehicle is stock then I would use the AFM tables only, and enable active tuning on those tables, and drive it a week and see what the fuel trims are like. If it has just an intake I would do the same thing.
Hondata