Hi Guy,
My 2017 CTR was turned by a local turner on dyno, and now my CEL is on I want to use the flashpro manager to check the error code.
But when I connected the flashpro manager it made an automatic update and show :
“ Caliberations are Read Protected. Please delete from FlashPro and upload orginal file to complete update ”
Since it is customer turned I don’t want to lose the data, is that any way I can draw out the turned data file from the flash pro, delete it and reinstall it after the update?
Thanks
Calibrations read protected issue
Re: Calibrations read protected issue
You can read the error code without reading or writing the calibration.
But if you want to upload a new calibration you will have to either have the password or erase the calibration that is on there.
But if you want to upload a new calibration you will have to either have the password or erase the calibration that is on there.
Hondata