Base MODS - FK8 - South Africa

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
CarloT
Posts: 10
Joined: Fri Jan 31, 2020 1:12 pm

Base MODS - FK8 - South Africa

Post by CarloT »

Hello everyone.

I just would like to get my base tune/mods setup as I have had way to many differences being told as to what to do.
I am based in South Africa and our fuel here is 95 Octane with apparently no ethanol.
The only mods I have is the Takeda Momentum Cold Air Intake System w/Pro 5R Filter Media and ofcourse Hondata - everything else is stock.
So below was the tune I created and then I took it in for Dyno which i did get some really good gains.
I have now heard and been told that's its not a good to enable full power on 1dt and 2nd as this does increase knock and I must admit it does.
Until i get all my mods right now I just want a decent setup - nothing to really over stress the engine.
Your thoughts as to what mods to enable?
Attachments
13.JPG
13.JPG (189.87 KiB) Viewed 3090 times
Post Reply