Page 1 of 1

07 Si With Bolt ons

Posted: Tue Apr 20, 2010 9:44 am
by FusionX9
Hi Hondata,

I wanted to ask what base mapping to start with for the following bolt ons:

Hondata Intake Manifold Gasket
Injen SRI
Vibrant Headers w/High Flow Cat
Vibrant Streetpower Gen2 Cat Back Exhaust

I also have the P2R TB Spacer and gaskets but they are not on yet.

I currently have a CEL light, can I delete this data event and just turn off the secondary oxygen Sensor?

Many Thanks,

Re: 07 Si With Bolt ons

Posted: Tue Apr 20, 2010 11:05 am
by yungming
FusionX9 wrote:Hi Hondata,

I wanted to ask what base mapping to start with for the following bolt ons:

Hondata Intake Manifold Gasket
Injen SRI
Vibrant Headers w/High Flow Cat
Vibrant Streetpower Gen2 Cat Back Exhaust

I also have the P2R TB Spacer and gaskets but they are not on yet.

I currently have a CEL light, can I delete this data event and just turn off the secondary oxygen Sensor?

Many Thanks,
With the bolts on, you can use the MAP calibration and use the calibration provided by Hondata in the FP Manager

Use the Civic-SI-Race-6-InjenCAI-RH calibration

Thanks

Posted: Wed Apr 21, 2010 6:02 am
by FusionX9
Thanks!

Posted: Wed Apr 21, 2010 6:38 am
by civicRSA
Don't use the InjenCAI calibration

Use Civic-Si-Race-6-InjenSRI-RH

Then in the calibration window. Go to the closed loop option and disable secondary O2 sensor.

Posted: Tue Apr 27, 2010 7:14 am
by FusionX9
Thanks for the updated info. That makes more sense to use the SRI cal.