I am running across an unusual problem here. I started off with the base map(which was not perfect) tuned it with wide band to a point where it works really good with the romulator. Now when i upload this map to a chip it runs like crap but when i run it off the laptop via romulator it runs great.
I am making sure that i am tuning in open loop and when i burn the chip it is still in open loop. Does anybody know of a potential fix for this issue?
Thank you
Issues Transferring tuned map to chip
Thanks for the response! The LED on the interface box is solid. Everything is normal.... solid LED no check engine light. I have tried two different interface boxes, I have tried the file on two different chips. I would like to say that when I say "it runs like crap" I do not mean that it is running so poor that it seems like it's in limp mode, rather the A/F ratio seems to move approx 1 to 1.5 points richer through the whole map when running on the chip. Yet when running on the Laptop/Romulator the A/F is great. I have tried moving fuel out broadly through the map then burning the chip and I have no luck as the map just seems to go all the heck.
-
- Posts: 192
- Joined: Wed Aug 22, 2007 12:41 am