B18c gsr skunk2 pro2

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
JekoB18c
Posts: 5
Joined: Sat Feb 01, 2020 2:04 am

B18c gsr skunk2 pro2

Post by JekoB18c »

Need help my car has

410 rdx injector
Skunk2 pro 2 cams
Supertech valve ,spring,retainers
Type r manifold and throttle body

Idle is so rough and rich
Sparkplugs are really black
When i press the gas it will rev up but the rpm will drop till 200 to 400 almost stall.
When warm up idle will be really rough
Please help
User avatar
Spunkster
Site Admin
Posts: 22741
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: B18c gsr skunk2 pro2

Post by Spunkster »

Has this been properly tuned on the dyno?
JekoB18c
Posts: 5
Joined: Sat Feb 01, 2020 2:04 am

Re: B18c gsr skunk2 pro2

Post by JekoB18c »

No not yet but i cannot drive my car to the dyno it always dies out ..1 time i tried to drive it and it dies out and it really hard for me to start it
User avatar
Spunkster
Site Admin
Posts: 22741
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: B18c gsr skunk2 pro2

Post by Spunkster »

See if your tuner can provide you with a basemap that runs it better, or you may want to consider towing it to the tuner to get properly tuned.
User avatar
CalibratEd
Posts: 1430
Joined: Fri Feb 07, 2020 3:20 pm

Re: B18c gsr skunk2 pro2

Post by CalibratEd »

Do you have a wideband on the car? I can help get the car running.
JekoB18c
Posts: 5
Joined: Sat Feb 01, 2020 2:04 am

Re: B18c gsr skunk2 pro2

Post by JekoB18c »

I think we found the problem we put the exhaust cam gear on -3 degrees instead of +3 degrees.i hope i dont have bent valve
Post Reply