Page 1 of 1

Build B16A Turbo

Posted: Fri May 24, 2019 11:09 am
by Sneaky_84
whats up guy i need an basemap to drive my car to the dyno.
my built is:
-JDM B16A CSS block
-JDM B16 head
-Supertecht valve train (flat valve)
-Skunk2 pro1 cams
-Edelbrock intake with 72mm throttlebody
-RC1200cc injector
-aeromotive regulator
-golden eagle fuelrail
-Ktuned 4 bar map sensor
-Hondata coil on plugs
-Arias piston 81.5mm (10.5:1)
-Skunk2 rods
-GSR tranny with competicion clutch stage 5
-GT35 turbo with 38mm wastegate 11psi spring
-2" hotside and 3" coldside
-Hondata s300v2 with bbg
-walbro 450lph pump
-8an feed lines with high flow filter

let me know what you have.


Re: Build B16A Turbo

Posted: Sat Jun 15, 2019 4:45 pm
by payam_fox
did you find a map ? i have attached one from my b16 built turbo low comp