Page 1 of 1

Please help.

Posted: Sun May 19, 2019 10:32 am
by b16Monty
I just recently finished soldering my s300 into my p06 ecu and when I plug the ecu into my car and key on the ignition I get two green lights to come on, But when I plug my ecu into my smanager I get one green light and one fast blinking red light and it will not let me load a calibration. (I registered my hondata board). ( I also cut j12). please help. thank you
Green light (d4)
Red light (d2)

Re: Please help.

Posted: Mon May 20, 2019 9:32 am
by Spunkster
What is he serial number that is on the s300 board inside the ECU?

From Help, About, what is the version of software you are using?