plx with s300?

s300 and SManager software questions & answers
mark3000
Posts: 44
Joined: Mon Aug 29, 2005 10:02 am

Post by mark3000 »

TurboLS wrote: and then adjust the offset in Hondata until they match.
Where in Hondata are you seeing the A/F ratio (besides when datalogging) I know where to adjust it, just dont know where to check it.
mark3000
Posts: 44
Joined: Mon Aug 29, 2005 10:02 am

Post by mark3000 »

found it, under sensors, change units from wideband to A/F
92hondalude
Posts: 10
Joined: Tue Apr 03, 2007 7:56 pm

Post by 92hondalude »

so should i run the cap?
or disable the o2 heater
User avatar
Spunkster
Site Admin
Posts: 22703
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

There is no cap. You can either disable the o2 heater or add a resistor to allow the ecu to think the heater is working.
92hondalude
Posts: 10
Joined: Tue Apr 03, 2007 7:56 pm

Post by 92hondalude »

oh ok.
but what about these caps i got.
should i run them or not.
Locked