alpha n question
alpha n question
i'm tuning an h22 with itb, as what i've read, i should use alpha n, to tune the car through tps. so u choose alpha n in my s300. i set the map reading to be 100mbar at tps =0, and 1bar at tps = 100%. however, when i datalog, the highlighted part goes to the middle column (around 500mbar) and playing arnd 500-800mbar. but the tps is reading only 6%. i cant get it tuned!!! help.....
you wont learn until you actually do it.
finally i got it to idle at 800rpm. i used 50mbar at tps = 0..
now the problem is, when im going WOT, it only goes to 500mbar (5th column). i only get readings at 1st 2nd, (idle), and 5th and 6th (500mbar), even if i just step tha gas a little, (tps = 10%) and when i go WOT (tps = 99%), it only goes up tp 500mbar.. :(
now the problem is, when im going WOT, it only goes to 500mbar (5th column). i only get readings at 1st 2nd, (idle), and 5th and 6th (500mbar), even if i just step tha gas a little, (tps = 10%) and when i go WOT (tps = 99%), it only goes up tp 500mbar.. :(
you wont learn until you actually do it.