Page 1 of 1

safety features

Posted: Thu Oct 20, 2005 11:28 am
by jdmspecdc5
I use both kpro and s300 but it is just recently that i noticed a difference in features. the kpro has overboost, lean, and overtemp safety features that i cannot find in the s300 parameters. also while the kpro has knock count the s300 only measures voltage. there is no way to make the MIL flash when knock is detected. am i just missing these features completely or are they just not incorporated into s-manager? the website advertises the over boost and over temp so i am assuming its in the program somewhere. knock and lean might just be kpro only. any ideas that can shed some light on this?