Hondata

My GF just picked up a EG with a GSR swap still running the stock ECU and it has a Skunk 2 intake Manifold. is there anyway i can save the file as a bin and write it to a chip so that she can get the full effect of the manifold?

What file? Do you have a Hondata installed in the car?

Its a p28 i chipped.. it would be the S200 but i dont have the blue box.

I was goin to make her new basemap that would be alot better than her p72 cause car feels like shit with it in there.

JDMLyfeStyle wrote:Its a p28 i chipped.. it would be the S200 but i dont have the blue box.

I was goin to make her new basemap that would be alot better than her p72 cause car feels like shit with it in there.

I don't think it will be possible for you to run the "bin" file from honda without the blue box. It will run, but probably in a "safe" mode.

whats so special about hondata bins so that it wouldnt work with a chipped p28?

The Hondata bins will work perfectly with your chipped P28, as long as you are also using the Hondata interface box. This is Hondata's way of protecting their "Intellectual property".

so i would need the blue box to be able to use the chip?

yes