Aim MXS 1.2 Strada Dash

s300 and SManager software questions & answers
Post Reply
jgadell
Posts: 7
Joined: Fri Nov 29, 2019 7:02 pm

Aim MXS 1.2 Strada Dash

Post by jgadell »

The install is extremely simple yet my AIM MXS gets 0 readings, is there a way I can test that my green 232TX wire from the S300 is outputting data?
User avatar
Spunkster
Site Admin
Posts: 22737
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Aim MXS 1.2 Strada Dash

Post by Spunkster »

Have you tried swapping RX and TX?

Are you sure the MXL and MXS use the same protocol?
jgadell
Posts: 7
Joined: Fri Nov 29, 2019 7:02 pm

Re: Aim MXS 1.2 Strada Dash

Post by jgadell »

I have not tried swapping the RX/TX in fear to maybe fry something. I can try the TX out of the S300 to the Aim's TX and see if maybe they messed up and vice versa. Apparently, they share the same protocol. I've seen some folks running the Strada dashes on Kpro's and S300's
jgadell
Posts: 7
Joined: Fri Nov 29, 2019 7:02 pm

Re: Aim MXS 1.2 Strada Dash

Post by jgadell »

Works, connected TX to TX versus TX to RX
DaX
Posts: 654
Joined: Tue Mar 18, 2003 3:48 pm

Re: Aim MXS 1.2 Strada Dash

Post by DaX »

Good to know. I've been eyeing the MXS 1.2 Strada.
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Aim MXS 1.2 Strada Dash

Post by Hondata »

TX and RX are always named from the viewpoint of the device. eg the S300 TX is the serial transmit from the S300. The MXS TX is the serial transmit from the AiM, so you need to connect TX to RX not TX to TX.
Hondata
Post Reply