knocking

s300 and SManager software questions & answers
Post Reply
robsy2
Posts: 13
Joined: Fri Jul 06, 2018 12:56 pm

knocking

Post by robsy2 » Thu Jun 13, 2019 12:04 pm

i have a 1998 integra b18c6 and its knocking when i bliip the throttle on downshifting for revmatching .. how do i adjust this

User avatar
Spunkster
Site Admin
Posts: 17658
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: knocking

Post by Spunkster » Thu Jun 13, 2019 1:14 pm

Have you tried decreasing the timing in the area where it is knocking?

robsy2
Posts: 13
Joined: Fri Jul 06, 2018 12:56 pm

Re: knocking

Post by robsy2 » Thu Jun 13, 2019 1:22 pm

No because i dont have a knocksensor but it happens just when i bliip the throttle for revmatch before i release the clutch so inn the low rpm i was thinking about adjusting the tip in retard .. im jusing the Stock 2001 itr calibration

robsy2
Posts: 13
Joined: Fri Jul 06, 2018 12:56 pm

Re: knocking

Post by robsy2 » Fri Jun 14, 2019 5:08 am

here is a logg when i idle and bliip the throttle
Datalog-190614-115645.s3d
(410.27 KiB) Downloaded 15 times

Post Reply