S300 V3 Uploaded base map wont Run
Posted: Thu May 09, 2019 1:31 pm
Recent purchase Of s300 v3. Pre socket.
sn37852
sofware version 2.7.2.0
Honda b16b with a OBd1 harness which then goes through a conversion harness to OBd2
History car run fine on original honda ecu
However with s300. is doing a strange thing. when the ignition is turn on the IACV in engine bay will humm. I can connect a laptop and can upload a base map however car will just idle at 2000 rpm. Any kind of throttle engine runs rough. I get the impression the map. though uploaded is not running and the only reason it is revving at 2000rpm is because the IACV is powered right open ( so to speak)
I also can not seem to do any kind of data logging..
Any kind of help would be grateful.
sn37852
sofware version 2.7.2.0
Honda b16b with a OBd1 harness which then goes through a conversion harness to OBd2
History car run fine on original honda ecu
However with s300. is doing a strange thing. when the ignition is turn on the IACV in engine bay will humm. I can connect a laptop and can upload a base map however car will just idle at 2000 rpm. Any kind of throttle engine runs rough. I get the impression the map. though uploaded is not running and the only reason it is revving at 2000rpm is because the IACV is powered right open ( so to speak)
I also can not seem to do any kind of data logging..
Any kind of help would be grateful.