question about PLX wideband

s300 and SManager software questions & answers
Post Reply
ochumi
Posts: 4
Joined: Fri Mar 30, 2018 3:55 pm

question about PLX wideband

Post by ochumi » Fri May 03, 2019 2:59 pm

hi i have a PLX wideband
i put wideband on d10 ELD narrowband on d14
the question

i have to disable heater o2 on hondata because the PLX module order that? because i don´t have to connect to pinout from ecu
wich mode i have to use for close loop¿? wideband (only for tune??, always) or narrowband

User avatar
Spunkster
Site Admin
Posts: 17647
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: question about PLX wideband

Post by Spunkster » Fri May 03, 2019 4:34 pm

You do not need to have the narrow band signal hooked up. You can run closed loop from the wideband input in D10. You should disable the heater error.

ochumi
Posts: 4
Joined: Fri Mar 30, 2018 3:55 pm

Re: question about PLX wideband

Post by ochumi » Sat May 04, 2019 10:18 am

I can disable the heater error here, can´t i? because the heater of the o2 works with the PLX module, doesn´t it?
Attachments
tura.PNG
tura.PNG (30.33 KiB) Viewed 964 times

User avatar
Hondata
Site Admin
Posts: 8630
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: question about PLX wideband

Post by Hondata » Sat May 04, 2019 6:55 pm

Yes, once you are using something other than the factory narrowband the o2 heater is not used.
Hondata

Post Reply