CEL, not appearing in Smanager, but blinking KOEO
Posted: Fri Sep 28, 2018 11:51 am
Hello,
I've got a chipped P28 (chipped by HAmotorsports) and an S300V3 board controlling a D16Z6 w/OBD0-->OBD1 harness. In key on/engine off position, I see a blinking check engine light (code 15). However, once the car is started there is no check engine light on the cluster, and SManager sees no fault codes when datalogging is activated. Trouble codes do show up correctly (I unplugged the IAT and ECT sensors, these immediately appeared as trouble codes). Is there anything that i'm missing that would cause the CEL15 (ignition output signal) to show up only in the KOEO position?
Thanks in advance!
Graham
I've got a chipped P28 (chipped by HAmotorsports) and an S300V3 board controlling a D16Z6 w/OBD0-->OBD1 harness. In key on/engine off position, I see a blinking check engine light (code 15). However, once the car is started there is no check engine light on the cluster, and SManager sees no fault codes when datalogging is activated. Trouble codes do show up correctly (I unplugged the IAT and ECT sensors, these immediately appeared as trouble codes). Is there anything that i'm missing that would cause the CEL15 (ignition output signal) to show up only in the KOEO position?
Thanks in advance!
Graham