Page 1 of 1
basemap d16y7 idle issues
Posted: Tue Sep 04, 2018 6:22 pm
by MrAhhsum
I have attached config and datalog
I have aem wideband 4110 (i believe) connected to d10 on my jumper harness.
I have sporadic idle, and it doesn't seem to calm down. I am looking for any input I can get.
the idle is fluctuating on my hondata ecu, but if i plug in factory obd2a ecu , it idles fine. Any thoughts?
Re: basemap d16y7 idle issues
Posted: Wed Sep 05, 2018 11:01 am
by Spunkster
With the Idle controller unplugged, what does it idle at?
Re: basemap d16y7 idle issues
Posted: Wed Sep 05, 2018 5:39 pm
by MrAhhsum
the idle air control valve ? I will check. Thank you for your reply
Re: basemap d16y7 idle issues
Posted: Fri Sep 07, 2018 9:39 am
by Spunkster
correct
Re: basemap d16y7 idle issues
Posted: Sat Sep 29, 2018 9:40 am
by tolyan
figured out?
Re: basemap d16y7 idle issues
Posted: Tue Oct 23, 2018 6:50 pm
by MrAhhsum
tolyan wrote: ↑Sat Sep 29, 2018 9:40 amfigured out?
not yet, i have not had time to go out and play with the iacv yet as suggested. Im hoping to update this weekend.
Re: basemap d16y7 idle issues
Posted: Sun Jan 13, 2019 4:55 pm
by MrAhhsum
Okay, been so busy I haven't been able to get to the car.
I unplug the y7 iac and the idle gets steady (car was warmed up already) so I think it's junk or needs cleaned again. Thanks guys.
Still open to other input
Re: basemap d16y7 idle issues
Posted: Tue Jan 15, 2019 9:03 am
by MrAhhsum
Come to think of it...
If the iacv works fine on stock ecu, and not my s300... Maybe it's a simple tuning issue.
Simple. Haha.
I've decided to wait to get running smooth until 8 get the build done. It's a toy anyways.
Thanks for the support people!