I have attached config and datalog
I have aem wideband 4110 (i believe) connected to d10 on my jumper harness.
I have sporadic idle, and it doesn't seem to calm down. I am looking for any input I can get.
the idle is fluctuating on my hondata ecu, but if i plug in factory obd2a ecu , it idles fine. Any thoughts?
basemap d16y7 idle issues
Re: basemap d16y7 idle issues
With the Idle controller unplugged, what does it idle at?
Re: basemap d16y7 idle issues
the idle air control valve ? I will check. Thank you for your reply
Re: basemap d16y7 idle issues
correct
Re: basemap d16y7 idle issues
Okay, been so busy I haven't been able to get to the car.
I unplug the y7 iac and the idle gets steady (car was warmed up already) so I think it's junk or needs cleaned again. Thanks guys.
Still open to other input
I unplug the y7 iac and the idle gets steady (car was warmed up already) so I think it's junk or needs cleaned again. Thanks guys.
Still open to other input
Re: basemap d16y7 idle issues
Come to think of it...
If the iacv works fine on stock ecu, and not my s300... Maybe it's a simple tuning issue.
Simple. Haha.
I've decided to wait to get running smooth until 8 get the build done. It's a toy anyways.
Thanks for the support people!
If the iacv works fine on stock ecu, and not my s300... Maybe it's a simple tuning issue.
Simple. Haha.
I've decided to wait to get running smooth until 8 get the build done. It's a toy anyways.
Thanks for the support people!