Problem putting into gear after upgrading to 2.6.6
Posted: Fri Jul 20, 2018 11:04 am
Hello,
Been running my Integra fine for 2 years using S300 v2.5.3
This morning I decided to update the software this morning, loaded the old calibration file from 2 years ago.
"Seems" ok and uploaded it to my ECU.
But as soon as I put it in reverse (to get out of my garage, or in gears) and try to give it gas, it dies.
Any quick "check list" or "major change" that I need to verify when going from 2.5.3 to the latest v2.6.6???
Edit: Also, why is Disable Knock Sensor checked by default?
Been running my Integra fine for 2 years using S300 v2.5.3
This morning I decided to update the software this morning, loaded the old calibration file from 2 years ago.
"Seems" ok and uploaded it to my ECU.
But as soon as I put it in reverse (to get out of my garage, or in gears) and try to give it gas, it dies.
Any quick "check list" or "major change" that I need to verify when going from 2.5.3 to the latest v2.6.6???
Edit: Also, why is Disable Knock Sensor checked by default?