Problem putting into gear after upgrading to 2.6.6

s300 and SManager software questions & answers
Post Reply
codenamezero
Posts: 26
Joined: Thu Dec 31, 2009 11:13 am

Problem putting into gear after upgrading to 2.6.6

Post by codenamezero » Fri Jul 20, 2018 11:04 am

Hello,

Been running my Integra fine for 2 years using S300 v2.5.3
This morning I decided to update the software this morning, loaded the old calibration file from 2 years ago.
"Seems" ok and uploaded it to my ECU.

But as soon as I put it in reverse (to get out of my garage, or in gears) and try to give it gas, it dies.

Any quick "check list" or "major change" that I need to verify when going from 2.5.3 to the latest v2.6.6???


Edit: Also, why is Disable Knock Sensor checked by default?

User avatar
Spunkster
Site Admin
Posts: 17770
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Problem putting into gear after upgrading to 2.6.6

Post by Spunkster » Fri Jul 20, 2018 12:07 pm

Without your calibration and a datalog showing the issue it is hard to say what it might be?

What is the serial number on the s200 inside the ECU?

Post Reply