Target Lambda table

s300 and SManager software questions & answers
Post Reply
skaterguy1986
Posts: 39
Joined: Mon Jan 01, 2018 7:31 pm

Target Lambda table

Post by skaterguy1986 » Fri Jun 22, 2018 9:04 am

Is there any way to change the values in this table? I'm asking because I'd like to run slightly lean at idle and cruising while using closed loop fuel control.

Thanks.

User avatar
Spunkster
Site Admin
Posts: 17770
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Target Lambda table

Post by Spunkster » Fri Jun 22, 2018 9:40 am

This can be changed on the closed loop advanced tab in parameters.

2x0
Posts: 87
Joined: Sat Feb 04, 2017 6:51 pm

Re: Target Lambda table

Post by 2x0 » Fri Jun 29, 2018 3:33 am

I thought these were controlled by going to Options > Settings > Target Lambda

The closed loop advanced parameters control what your wideband will try to actually adjust to when driving in closed loop.
'91 CRX, B18c1, T3/T4, 17psi on e85, FIC 1000cc's, S300 V3 P28

User avatar
Spunkster
Site Admin
Posts: 17770
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Target Lambda table

Post by Spunkster » Fri Jun 29, 2018 9:53 am

Those settings will not have any effect on your closed loop operation. The settings I have mentioned are what control this.

skaterguy1986
Posts: 39
Joined: Mon Jan 01, 2018 7:31 pm

Re: Target Lambda table

Post by skaterguy1986 » Thu Aug 02, 2018 4:23 pm

That table in the closed loop advanced window is a bit too broad of an adjustment. I wanted to go into the tables window>"show target lambda" and adjust the idle and light throttle cruise so that it targets something a tad leaner like 15:1 but when I tried to alter the numbers it just adjusted the fuel value.

Post Reply