rev and ign cut randomly

s300 and SManager software questions & answers
Post Reply
Mafia
Posts: 33
Joined: Mon Jun 09, 2008 4:35 pm

rev and ign cut randomly

Post by Mafia »

Hello, I'm trying to help a friend out with his car.

I cant find anything in the logs that tells me why its cutting out.

The car randomly cuts out and I see Rev limit and ignition cut
Hondata s300
hondata COP
built engine
Turbo 6266.

Please help, Thanks
Attachments
streetb.s3d
(149.61 KiB) Downloaded 112 times
batman street.skl
(43.76 KiB) Downloaded 115 times
Eg 800hp - Track car
Eg 580hp - daily
User avatar
Spunkster
Site Admin
Posts: 22798
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: rev and ign cut randomly

Post by Spunkster »

Try disabling on board datalogging and see if the same problem persists.
Mafia
Posts: 33
Joined: Mon Jun 09, 2008 4:35 pm

Re: rev and ign cut randomly

Post by Mafia »

We gave that a try today, Same problem.

So Ill give you some back ground on the car, might be related, might not be.

So spring time he took the car down (it ran good, no problems.)

He changed the Turbo manifold, Intercooler, Installed hondata COP, Installed fuel cell with 044 pumps.

Car ran good for about 10 Pulls (down the drag strip), then started have this ign/rev cuts.


Soo, We gave me ecu a try with no luck, Can it be COP related?

Is there any way to see whats triggering the ign/rev cut?
Eg 800hp - Track car
Eg 580hp - daily
User avatar
Spunkster
Site Admin
Posts: 22798
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: rev and ign cut randomly

Post by Spunkster »

Most likely related to the CPR setup. What is the part number for the spark plugs you are using. Are they resistor or non-resistor type?
Mafia
Posts: 33
Joined: Mon Jun 09, 2008 4:35 pm

Re: rev and ign cut randomly

Post by Mafia »

Bkr7e NGK resistor type, what do I need to test and how?
Eg 800hp - Track car
Eg 580hp - daily
User avatar
Spunkster
Site Admin
Posts: 22798
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: rev and ign cut randomly

Post by Spunkster »

I would start by borrowing a different distributor to see if the problem is related to that (should be an OEM distributor, not aftermarket). Also try a different ECU as we have seen some ECUs cause issues.
Mafia
Posts: 33
Joined: Mon Jun 09, 2008 4:35 pm

Re: rev and ign cut randomly

Post by Mafia »

Alright We tried my Distributor (oem) , my ecu.


We changed engine harness (last one looked a little beat up)
Changed TPS
changed alt
changed battery


Sounds like he getting ready to part out... So It would be nice to get it figured out before he gives up.

Anyway, We are trying to find a stock Dizzy to bypass COP all together, But I honestly ran out of ideas.

SO is there any way to see whats causing the ecu to turn on IGN and Rev ?
Eg 800hp - Track car
Eg 580hp - daily
User avatar
Spunkster
Site Admin
Posts: 22798
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: rev and ign cut randomly

Post by Spunkster »

No, there is nothing you can see that shows the cause. All you can do is try process of elimination until you narrow it down to something specific.
User avatar
Hondata
Site Admin
Posts: 10448
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: rev and ign cut randomly

Post by Hondata »

Normally it is the ECU getting a bad signal from the distributor, and it will rev limit without a code. Also I see your battery voltage is dropping too.
Hondata
Post Reply