2500 RPM Rev Limit w/ s300
Posted: Sat Feb 21, 2015 2:57 pm
First time using the s300 so I'm sorry if i missed a something stupid....
91 CRX si - D16A6 converted to OBD1 using the Rywire Kit.
92 Civic Distributor
Rebuild Motor with Vitara Pistons 75.5mm , Eagle Rod H Beams , ACL Racing Bearing ( Notched and Decked )
Car Runs a little rough at the moment during warm up and idle but runs great under load....until i hit ~ 2499 rpm. Fuel cuts out and will not accelerate any more. Not sure if i missed a setting or what happened but i got a basemap from HA Motor sports for the d16a6. Found out later it was just the re branded stock p28 basemap with no VTEC. Also getting a 21 VTEC spool error but i dont have VTEC.
Any help would be greatly appreciated!
91 CRX si - D16A6 converted to OBD1 using the Rywire Kit.
92 Civic Distributor
Rebuild Motor with Vitara Pistons 75.5mm , Eagle Rod H Beams , ACL Racing Bearing ( Notched and Decked )
Car Runs a little rough at the moment during warm up and idle but runs great under load....until i hit ~ 2499 rpm. Fuel cuts out and will not accelerate any more. Not sure if i missed a setting or what happened but i got a basemap from HA Motor sports for the d16a6. Found out later it was just the re branded stock p28 basemap with no VTEC. Also getting a 21 VTEC spool error but i dont have VTEC.
Any help would be greatly appreciated!