AF display not going below 12 or above 19

s300 and SManager software questions & answers
Post Reply
DOHCAccord
Posts: 78
Joined: Tue Apr 05, 2005 9:33 am

AF display not going below 12 or above 19

Post by DOHCAccord »

Hello,

while datalogging my s300 display will not read below 12 or above 19 for AF.
My wideband will go to as low as 10 before showing rich and 20 before showing lean...

The wideband is accurate but the display will not show the higher or lower numbers...

any ideas on this?

User avatar
Spunkster
Site Admin
Posts: 18152
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: AF display not going below 12 or above 19

Post by Spunkster »

You need to provide much more information such as what wideband you are using, what input you are using on the s300 and exactly how you have it all wired.

DOHCAccord
Posts: 78
Joined: Tue Apr 05, 2005 9:33 am

Re: AF display not going below 12 or above 19

Post by DOHCAccord »

the wideband is the PLX m-300 and is wired into the ecu via the D10 input

User avatar
Spunkster
Site Admin
Posts: 18152
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: AF display not going below 12 or above 19

Post by Spunkster »

Have you removed the resistors as it says in the help file?

http://www.hondata.com/help/smanager/wi ... ub=eld+d10

DOHCAccord
Posts: 78
Joined: Tue Apr 05, 2005 9:33 am

Re: AF display not going below 12 or above 19

Post by DOHCAccord »

i opened the case and the resistors are in place.. how do you recommend removing them from the ecu?

Luke
Posts: 249
Joined: Thu Mar 26, 2009 10:24 am
Location: Dorsten/Germany

Re: AF display not going below 12 or above 19

Post by Luke »

DOHCAccord wrote:i opened the case and the resistors are in place.. how do you recommend removing them from the ecu?
solder them out. easy as that.

User avatar
Spunkster
Site Admin
Posts: 18152
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: AF display not going below 12 or above 19

Post by Spunkster »

Or cut them out with a wire cutter.

Post Reply