B8 sticking

SPOOLIN · Post by **SPOOLIN** » Tue Mar 16, 2010 7:47 pm

I tried using B8 as my burnout rev limit or data lot and it sticks, i cant turn it off, even when i dont have a wire on it...it wont turn off once enabled. If i disable it obviously it stops.

fly_n · Post by **fly_n** » Tue Mar 16, 2010 10:06 pm

U have to switch the PSP input high to low to turn it off by default.
It is normally closed circuit on a stock car with pwr steer.
PSP input goes open circuit when switch sees pressure,ie it goes high.
So no wire attached & ecu thinks its seeing pressure...

U are using a ground input arent u?

SPOOLIN · Post by **SPOOLIN** » Wed Mar 17, 2010 6:42 pm

yeah its a wire fro the pin to a switch and then to ground so the switch just grounds the pin. What setting reverses what you are saying?

fly_n · Post by **fly_n** » Wed Mar 17, 2010 9:30 pm

Just invert the input(little checkbox next to where u declare the switch input) it will then switch 'on' with high to low input from your switch,assuming your switch is set up normally open.

Or if u have a double throw switch just wire it normally closed.

SPOOLIN · Post by **SPOOLIN** » Tue Mar 23, 2010 3:18 pm

using the check box worked but the one day i tried it, its like it wouldnt change anything.