K24 Frankenstein

K-Series Programmable ECU Calibration updates / downloads
Post Reply
BigSloth
Posts: 1
Joined: Mon Oct 14, 2019 11:14 am

K24 Frankenstein

Post by BigSloth » Tue Oct 15, 2019 9:51 am

Hi so ive recently built a k24 frank and need bit of advice and help on what base map to run to break the engine in, the spec is as follows

2005 European civic type r (ep3)
PRA ecu with Kpro v4
K24a3 stock bottom end (european, same as usdm k24a2)
K20a2 Stock head
K20a2 stock inlet manifold
K20a2 Stock manifold with cat
2.5inch Cat back

So if anyone could guide me on which map to use or provide me with a map so i could break in my clutch and get my car MOT before i take it to dyno to get it tuned with decat and ITBS would be much appreicated

Hpmengine
Posts: 11
Joined: Thu Sep 05, 2019 5:22 am

Re: K24 Frankenstein

Post by Hpmengine » Sat Nov 09, 2019 1:27 pm

HI
Made several cars with these MODS ....
What is your project?
I started from this calibration
PRA - Euro Civic Type R / S2000
I hope to see your great result
regards

Post Reply