MIL Flash for Shift Light?

BMR · Post by **BMR** » Sat Sep 27, 2008 11:10 am

Is there any way to activate the MIL light as a shift light like the S300?

THanks

LK7R · Post by **LK7R** » Mon Dec 01, 2008 2:21 am

This featrue would be so great! ... Hondata?

LK7R · Post by **LK7R** » Wed Dec 17, 2008 5:14 am

Bump ... please?

Post by **Hondata** » Wed Dec 17, 2008 9:49 am

Probably not going to happen. The MIL is already used for knock indication, and it would be best to keep the operation simpler. If you want a shift light output you can use a nitrous output to drive a LED.

LK7R · Post by **LK7R** » Thu Dec 18, 2008 12:20 am

Thank you for the reply.

Or Immobiliser / EPS light :)

OK so with nitrous:

First wire from LED to 12V and second wire to E18/E20/E21/B6 (Ground) ? (not sure about the wiring)

K-Manager settings / Nitrous control:
- Arming input - Always on

- Engine speed set to RPM window where LED should be ON
- Engine load to some low value
- Throttle to some low value
- Vehicle speed to 0
- Knock count to 0

- Fuel and Ign - no corrections

thank you

Dan

Post by **Hondata** » Thu Dec 18, 2008 9:45 am

Sounds ok.

Switch 12V to one side of the LED. Other side of the LED to the ECU (E20/E21) using a resistor to control the current.

LK7R · Post by **LK7R** » Fri Dec 19, 2008 1:31 am

Good!

Will test it out.

cheers

Dan