Log: Domain error
-
- Posts: 7
- Joined: Sat May 12, 2018 12:57 pm
- Location: Switzerland
Log: Domain error
Hi
I can download from my ecu to kpro with 4.3.5 but when i start datalogging (F10) then pop up hundrets of error windows with the Message „log : DOMAIN error“.
What is the problem? Some months ago all was fine, but now this problem. Is it a problem with the new update?
I can download from my ecu to kpro with 4.3.5 but when i start datalogging (F10) then pop up hundrets of error windows with the Message „log : DOMAIN error“.
What is the problem? Some months ago all was fine, but now this problem. Is it a problem with the new update?
-
- Posts: 7
- Joined: Sat May 12, 2018 12:57 pm
- Location: Switzerland
Re: Log: Domain error
Hope you can see it attached
- Attachments
-
- 4BB2DB51-0869-4546-A52E-F27BCF1D6228.jpeg (265.29 KiB) Viewed 2437 times
Re: Log: Domain error
Have you uploaded the calibration back to the KPro with the new version?
Hondata
-
- Posts: 7
- Joined: Sat May 12, 2018 12:57 pm
- Location: Switzerland
Re: Log: Domain error
Yes, but the same problem..
- Attachments
-
- 14-05-2018 21-11-04.jpg (564.63 KiB) Viewed 2425 times
Re: Log: Domain error
What is the serial number that is on the K-Pro board?
-
- Posts: 7
- Joined: Sat May 12, 2018 12:57 pm
- Location: Switzerland
Re: Log: Domain error
Serialnumber is 44525
- Attachments
-
- 7157AAB2-E1F8-4DAA-9086-E58C61369C27.jpeg (2.71 MiB) Viewed 2413 times
Re: Log: Domain error
Can you please post your calibration so that we can take a look at it.
-
- Posts: 7
- Joined: Sat May 12, 2018 12:57 pm
- Location: Switzerland
Re: Log: Domain error
Which calibration do you want to see?
Re: Log: Domain error
The one you are running.
-
- Posts: 7
- Joined: Sat May 12, 2018 12:57 pm
- Location: Switzerland
Re: Log: Domain error
Sure, I hope you find something
- Attachments
-
- Betz Test.kal
- (162.39 KiB) Downloaded 116 times
Re: Log: Domain error
Where did you get this calibration?
Re: Log: Domain error
This is because you have negative values for the voltage offset on your analog inputs. Remove the negative value and it will not give the error.
-
- Posts: 7
- Joined: Sat May 12, 2018 12:57 pm
- Location: Switzerland
Re: Log: Domain error
you are right!
with no negative values for the voltage it is working..
special, because I never changed it since last season and last year it worked. I think it is since I changed to update 4.3.5
with no negative values for the voltage it is working..
special, because I never changed it since last season and last year it worked. I think it is since I changed to update 4.3.5