can not get kpro 4 analog to read psi???
can not get kpro 4 analog to read psi???
Anyone here know how to get kpro 4 analog input to read PSI instead Voltage? I change the unit to PSI or bar and it still show Voltage. Oil pressure and fuel pressure is what I'm trying to do.
Re: can not get kpro 4 analog to read psi???
Can you post your calibration and datalog showing the issue?
Re: can not get kpro 4 analog to read psi???
Ok here is my calibrations and datalogs that I did. Let me know if I miss anything else.
- Attachments
-
- Pao MR2 K20 Nov 2017 E98 37psi NEW VERSION.kal
- (170.35 KiB) Downloaded 121 times
-
- datalog4.kdl
- (491.32 KiB) Downloaded 110 times
-
- datalogh3.kdl
- (600.87 KiB) Downloaded 93 times
-
- datalog2.kdl
- (427.26 KiB) Downloaded 96 times
Re: can not get kpro 4 analog to read psi???
They are showing readings. The conversion table you enter must be in BAR, then you can set the unit to PSI , then in the sensor window change them units for each input to psi as well with a reasonable min and max value.
Re: can not get kpro 4 analog to read psi???
WOW! change it to bar and it works. Thanks man.